Check the Fit of Your Cut for Base & Shoe Molding Installation

Video Transcript

So we’ve got our first piece cut. We’ve got the left edge flat still since it is going against this wall here this corner and we’ve got our other end with a 15 degree angle because it goes against this door jamb here and we want more of a finished edge there. So we will give a little bit of a angle cut. And you just set it in place and if you could see, covers crack that is there’ press it there against the wall. And the reason we do not put another piece down here in this corner, is just because it is so short, there is no need for one because one would not fit anyway. So you got our shoe molding in. What we are going to do is since we’ve got a few more pieces to cut, we’re going to go ahead and demonstrate the other cutting techniques that you’re going to need to know and then once we’re done with that, we will go ahead and nail everything in at the same time at the end.

Watch these related videos

• 
  Check the Fit of Your Cut for Base & Shoe Molding Installation

  playlist Views: 6,996

• 
  Measuring the Molding for Base Molding Installation

  playlist Views: 8,102

• 
  Outside Corner Measurement for Base Molding Installation

  playlist Views: 8,352

• 
  Cleaning Up the Outside Corners for Base Molding Installation

  playlist Views: 5,977

• 
  How to Cut a Fifteen Degree Angle for Base Molding Installation

  playlist Views: 8,620

• 
  Introduction & Basic Overview of Base Molding Installation

  playlist Views: 11,685

Community Members who...

• Favorited this Video
• Rated This Video

Thumbs up or Thumbs down? Be the first to rate this video!

Top Tags