How to Remove Devices on Motorcycle

Video Transcript

Ok, in this clip what we're going to do is we're going to be removing the air cleaner cover and then we're also going to be going on the other side and removing the horn, to allow us access to the other side of the bike. Ok now this is a stock air cleaner cover. There's a gasket that runs around, the cover itself. Be careful not to lose it. He's got a very dirty air filter, which is going to need to be replaced. Then he's got the breather bolt, carryover. Basically you need to make sure that these aren't dried up too bad, these are ok. In this clip we're going to remove the horn "grab the assembly, there you go. There, you want to be careful with that," and there's two wires, that lead to the horn. There's usually a medal clamp, that's holding the wires out of the way, you can pull it out. Generally you can pry it back with your fingers and after the horn removal, we'll disconnect the choke cable "yeah just pry it open with your fingers, there you go."

Watch these related videos

• 
  How to Remove Devices on Motorcycle

  playlist Views: 381

• 
  Removing Motorcycle Wires

  playlist Views: 331

• 
  How to Disconnect Battery from Motorcycle

  playlist Views: 644

• 
  How to Install a Bathroom Light Fixture

  playlist Views: 7,023

• 
  Removing Parts to Change Car Thermostat

  playlist Views: 1,616

• 
  How to Remove a Motorcycle Wheel

  playlist Views: 3,701

Community Members who...

• Favorited this Video
• Rated This Video

Thumbs up or Thumbs down? Be the first to rate this video!

Top Tags