Install A Frame Assembly on Pool Vac Ultra

Video Transcript

Well, we have been completely rebuilding our pool vac ultra, replacing all the parts and the next thing we would wont to do after we got this top part done is, well the action happens here at the bottom, so we need to replace or put back in these A frames. Now these guys roll on top of the turbine and they go back an forth, opposite of each other and make the little pods go back an forth, so you wont to make sure again that there free spinning, in this case its new, because were replacing theses parts and we got some new bushing assemblies. First thing, you would wont to do is to put the bushing assembly in, they are notch but flatten on one side so you would know exactly how to put them in. They will only go in one way and they will stay petrueded on both sides. Next thing you wont to do is set in the bottom part of the bushing, what this will do is keep the A frame in place, were it can move smoothly in the water, just seated it in there, it will sit nice an even. Take the A frames an install it, there is no wrong way or right to left way to install it. It will sit perfectly. Now take the bearing cover and seat it on top and install the screw, it will have a star washer, lock washer and its a little flat line. It will go right into the top, an a couple of turns with a drill and the A frames are ready to dance.

Watch these related videos

• 
  Install A Frame Assembly on Pool Vac Ultra

  playlist Views: 804

• 
  Installing the A-Frames on a Hayward Aquabug

  playlist Views: 407

• 
  Remove A Frames of Pool Vac Ultra

  playlist Views: 813

• 
  Remove Lower Portion of Pool Vac Ultra

  playlist Views: 845

• 
  Install Gearbox on Pool Vac Ultra

  playlist Views: 973

• 
  Troubleshoot Pool Vac Ultra Turbines

  playlist Views: 1,580

Community Members who...

• Favorited this Video
• Rated This Video

Thumbs up or Thumbs down? Be the first to rate this video!

Top Tags