Remove Lower Portion of Pool Vac Ultra

Video Transcript

Sometimes over years it becomes necessary to go in and repair major parts of the cleaner. Double check that they are working properly and replace them if necessary. Now we are going to show you how to remove the lower compartment to expose the turbine and the A frame assembly. The first thing you want to do is remove the cover assembly. Remember to keep your drill set on the lowest torque setting so that it doesn't destroy the unit and then you are going to find four bulbs and it will hold one, two, three and four and we are going to remove those. Obviously it is a lot easier to use the screw gun and make sure that you have one with a little bit of a reach like this. These with the removable heads are nice and this turns out to be a quarter inch nut driver and this is something we will get to later in the Pool Vac Ultra but unlimited reach goes a long way. Now while keeping track of your screws we will just gently wiggle and we get to see the innards, the heart and soul of the Pool Vac Ultra and in a minute we will show you how to repair some of these.

Watch these related videos

• 
  Remove Lower Portion of Pool Vac Ultra

  playlist Views: 980

• 
  Hayward Pool Vac Ultra

  playlist Views: 3,070

• 
  Remove Shroud on Pool Vac Ultra

  playlist Views: 816

• 
  Install Turbines on Pool Vac Ultra

  playlist Views: 973

• 
  Install Gearbox on Pool Vac Ultra

  playlist Views: 1,160

• 
  Troubleshoot Pool Vac Ultra Turbines

  playlist Views: 1,816

Community Members who...

• Favorited this Video
• Rated This Video

Thumbs up or Thumbs down? Be the first to rate this video!

Top Tags