Ending Off a Spiral Knot Hemp Bracelet

Video Transcript

Hi I'm Karen for Expert Village I'm going to show you how to end our spiral knot bracelet with an end knot. First lets cut off our extra thread that was holding that, we don't want to cut up our loop, just our thread, and then we're going to take all the strands and tie that figure 8 knot. So come around your finger across the front, around the back and back through the hole and then you want to tie it as close to the end of the pieces as possible. We'll do a little of wiggling to get that down there and pull it down nice, and tight, figure 8 makes a good lumpy knot cause we need that to hold the bracelet on. Pull it nice and tight and remember to leave about a quarter inch on the end, don't cut it right up close becuase the could cause the knot to come undone, about a quarter inch __ discard that and then you can open up your loop put your loop right up on there, the loop just gets caught on the knot like that and that's our spiral bracelet.

Watch these related videos

• 
  Ending Off a Spiral Knot Hemp Bracelet

  playlist Views: 4,584

• 
  Ending Off the Alternating Knot Hemp Bracelet

  playlist Views: 4,883

• 
  Ending Off a Square Knot Hemp Bracelet

  playlist Views: 5,508

• 
  Setting Up the Alternating Knot Hemp Bracelet

  playlist Views: 4,667

• 
  Securing your Hemp Jewelry

  playlist Views: 4,270

• 
  Making a Spiral Knot Hemp Bracelet

  playlist Views: 30,414

Community Members who...

• Favorited this Video
• Rated This Video

Thumbs up or Thumbs down? Be the first to rate this video!

Top Tags