Motorcycle Fuel Injection Tuning Module Installation Tips

Video Transcript

Alright, now that we have our exhaust done it's time to install this Dino Jet Power Commander. It's a USB so you can plug it into your computer and load any kind of map into it. This one is already set up and ready to go. All we have to install is the map that is made for this exhaust and a factory air cleaner. So, first thing you want to do since we already have the seat off is we're going to go ahead and remove the back tail here. Take this off. Go ahead and take these side panels off; slide them out. You have to remove the tank. Just pop the tank up when you do these, because we need to get down to the fuel injector sensors. So you just take off this front bolt of the tank. Normally in the back of your bike there is going to be a long metal rod and that's called the tank prop. So, we'll just look back here and see if this bike has one; and it does. It looks just like this and that is what that is for. What you do is you lift the tank and put this inside here and this right in there and bam the tank is up. You're ready to get inside and find all your sensors. Alright, what I'm going to do first is get this mounted in the back and run the necessary wiring straight forward to where it's got to go so it looks nice and clean. This we're just going to kind of run straight forward here. Make sure you have all your wires running nice and neat and not getting in the way of any of your body panels going back on. Here is your ground wire. Run the ground wire straight over to the battery. Have it ready to go. That's going just; it's already got a loop on it so all you have to do is take this off with a Phillips and tap it on. That's done. Then this we are going to run under. Alright, now we've got all the wires ran we're going to find the connectors for the lower stock injectors which are not the top ones, they are the lower ones. Now that we've removed all of the lower injector plugs we're just going to take the power commander side, the black plug, just click in like this. Just like that. We're going to take the other side of the pigtail and plug it right back into where we first unplugged these. Alright, now that we've got all of our injectors all in place and connected the one last connection that we need to do under the tank is to find the TPS, the throttle position sensor. It's right here, it's real short, but what you want to do is find the pink with black wire and we're going to put a little scotch lock on it. Then in the harness there is this wire that came with the injectors and this is all in line and we're just going to put a scotch lock on this pink wire, plug it in and plug this back into the throttle body and that will be done under the tank. All we have to do is go back here, ground it, and load the map. This whole bike is going to be done.

Watch these related videos

• 
  Motorcycle Fuel Injection Tuning Module Installation Tips

  playlist Views: 592

• 
  Motorcycle Fuel Injector Software Tips

  playlist Views: 399

• 
  Motorcycle Wire Removing Tips

  playlist Views: 324

• 
  Diagnosing Injection for Fuel Pump Repair

  playlist Views: 1,325

• 
  How to Change Motorcycle Spark Plugs

  playlist Views: 9,589

• 
  Fuel Efficiency Tips: Fuel Injector Cleaner

  playlist Views: 2,344

Community Members who...

• Favorited this Video
• Rated This Video

Thumbs up or Thumbs down? Be the first to rate this video!

Top Tags