Reattaching Brake Hose When Changing Front Coil Springs on a Ford Taurus

Video Transcript

In this step I'm going to demonstrate the proper service procedure for reattaching your brake hose mounting hardware and your anti-lock wheel speed sensor mounting hardware. Now we have the brake hose right here and it's got this little bolt that goes through here into the back of the strut tab, I'm going to go ahead and get this one started for you. Alright got her started and going to go ahead and use my quarter inch ratchet and a ten millimeter socket. Alright there, alright this here is a spring clip we're going to take and pop it onto the strut just like so. Now this guy holds your anti-lock wheel speed sensor wire and you can see these guys just slip right on here. Give them a little roll so they slide into place there and there, go ahead and make everything is attached. That is the proper service procedure for attaching your brake hose mounting hardware and your anti-lock brake wheel speed sensor wire mounting clip.

Watch these related videos

• 
  Reattaching Brake Hose When Changing Front Coil Springs on a Ford Taurus

  playlist Views: 773

• 
  Unbolting Brake Hose When Changing Front Coil Springs on a Ford Taurus

  playlist Views: 1,075

• 
  Reinstalling a Brake Hose, Retaining Clip & Anti-Lock Mounting Bolt

  playlist Views: 578

• 
  Removing a Brake Hose, Retaining Clip & Anti-Lock Mounting Bolt

  playlist Views: 942

• 
  Remounting Rear Axle Brake Hoses

  playlist Views: 614

• 
  Reassembling Coil Spring When Changing Front Coil Springs on a Ford Taurus

  playlist Views: 1,453

Community Members who...

• Favorited this Video
• Rated This Video

Thumbs up or Thumbs down? Be the first to rate this video!

Top Tags